Product ID:X-6138 YELLOW SILICONE ENAMEL 13695
MSDS Date:03/02/1992
FSC:8010
NIIN:01-211-1104
MSDS Number: BQCYF

FARWEST PAINT MANUFACTURING CO

4522 SOUTH 133RD STREET
TUKWILA, WA 98168
US

Emergency Phone: 206-941-1619

Info Phone: 206-244-8844

Preparer: NORMA HABEEB

Cage: 2F266

FARWEST PAINT MANUFACTURING CO

TUKWILA, WA 98168 US

Telephone: 206-244-8844

Cage: 2F266

ALIPHATIC HYDROCARBON

CAS: 8032-32-4

RTECS: OI6180000

Fraction By Weight: 54.0%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM

526 GRAMS/LITER (LESS WATER)

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN: IRRITATION, OR DEFATTING OF SKIN
UPON PROLONGED OR REPEATED CONTACT. INHALATION: EXCESSIVE EXPOSURE
TO VAPORS OR SPRAY MISTS CAN RESULT IN HEADACHE, DIZZINESS, NAUSEA,
LOSS OF CONSCIOUSNESS. SOM E REPORTS HAVE ASSOCIATED REPEATED
PROLONGED OVEREXPOSURE TO SOLVENTS TO PERM BRAIN & NERVOUS SYSTEM
DAMAGE.
Explanation of Carcinogenicity:THIS PRODUCT CONTAINS NO KNOWN
CARCINOGENS IN REPORTABLE QUANTITIES AS DEFINED BY ACGIH, OSHA,
NTP, IARC.
Medical Cond Aggravated by Exposure:NONE WHEN USED IN ACCORDANCE WITH
SAFE HANDLING INSTRUCTIONS.

First Aid:SKIN: PROMPTLY WASH W/SOAP & WATER. REMOVE & WASH
CONTAMINATED CLOTHING BEFORE REUSE. EYES: FLUSH W/LRG QTY OF WATER
15 MINUTES & SEEK MEDICAL AID. SWALLOWING: DONT INDUCE VOMITING,
KEEP WARM, QUIET & GET MED AID. ASPIRATION OF MATERIAL INTO LUNGS
CAN CAUSE CHEMICAL PNEUMONITIS WHICH CAN BE FATAL. INHALATION:
REMOVE TO FRESH AIR IMMED. IF RESPIRATORY SYMPTOMS DEVELOP, GET MED
AID IMMEDIATELY.

Flash Point Method:TCC
Flash Point:107F,42C
Lower Limits:0.7
Upper Limits:6.0
Extinguishing Media:FOAM, DRY CHEMICAL, WATER FOG, CO2, OR ANY CLASS B
EXTINGUISHING AGENT
Fire Fighting Procedures:FIREFIGHTERS & OTHER EXPOSED TO VAPORS OR
COMBUST PRODUCTS SHOULD WEAR SCBA. EVACUATE AREA OF UNPROTECTED
PERSONNEL. WEAR PROTECTIVE CLOTHING.
Unusual Fire/Explosion Hazard:VAPOR MAY FORM AN EXPLOSIVE MIXTURE IN
AIR & MAY BE IGNITED BY SPARKS, PILOT LIGHTS, ETC. CLOSED
CONTAINERS MAY RUPTURE WHEN EXPOSED TO EXTREME HEAT.

Spill Release Procedures:REMOVE IGNITION SOURCES. VENTILATE AREA.
ABSORB SPILL WITH ABSORBENT (SAWDUST, VERMICULITE, SAND), PLACE IN
CLOSED CONTAINER. IF LARGE SPILL, DIKE AREA TO PREVENT MATERIAL
ENTERING WATER SYSTEMS OR SE WERS. WEAR PROTECTIVE EQUIPMENT DURING
CLEANUP.

Handling and Storage Precautions:AVOID PROLONGED OR REPEATED INHALATION
OF HEATED VAPORS OR SPRAY MISTS. KEEP AWAY FROM HEAT OR OPEN FLAME.
THIS MATERIAL MAY CAUSE SENSITIZATION.
Other Precautions:DONT GET IN EYES, ON SKIN OR CLOTHING. DONT ALLOW
CONTAMINATED CLOTHING TO CONTACT SKIN. DO NOT WELD ON FULL/EMPTY
CONTAINERS. KEEP CONTAINERS CLOSED WHEN NOT IN USE AND PROPERLY
LABELED. MATERIAL CAT EGORIZED BY SARA TITLE III: ACUTE, FIRE.

Respiratory Protection:A CANISTER TYPE RESPIRATOR MUST BE WORN TO
PREVENT INHALATION OF VAPORS OR SPRAY MISTS WHEN TLV OR PEL
EXCEEDED.
Ventilation:GENERAL VENT REQUIRED DURING NORMAL USE. LOCAL VENT MAY BE
REQ'D DURING CERTAIN OPERATIONS (KEEP BELOW TLV/PEL).
Protective Gloves:CHEM RESISTANT NITRILE,NEOPRENE,RUBBER
Eye Protection:WEAR FACE SHIELD OR CHEMICAL GOGGLES.
Other Protective Equipment:WEAR PROTECTIVE CLOTHING TO PREVENT SKIN
CONTACT. EYE WASH STATION AND SAFETY SHOWER SHOULD BE AVAILABLE.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING.
Supplemental Safety and Health

HCC:F4
Boiling Pt:B.P. Text:307 TO 387F
Vapor Pres:2.6 @ 20C
Vapor Density:> AIR
Spec Gravity:8.12 LBS/GAL
Viscosity:67-77 KU
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:YELLOW LIQUID/MILD AROMATIC ODOR
Percent Volatiles by Volume:52

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDANTS, ACIDS, BASES AND EPOXY HARDENERS
UNDER UNCONTROLLED CONDITIONS.
Stability Condition to Avoid:HEAT, SPARKS AND OPEN FLAMES. IF PRODUCT
CONTAINS ALUMINUM, MOISTURE IN CLOSED CONTAINERS WILL GENERATE
HYDROGEN GAS.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION CAN YIELD CARBON
MONOXIDE AND TOXIC VAPORS.
Conditions to Avoid Polymerization:HEAT, SPARKS, OPEN FLAMES. IF
PRODUCT CONTAINS ALUMINUM MOISTURE IN CLOSED CONTAINERS WILL
GENERATE HYDROGEN GAS.

Waste Disposal Methods:DISPOSE IN ACCORDANCE WITH FEDERAL, STATE &
LOCAL AGENCIES. GROUND HANDLING EQUIPMENT TO PREVENT SPARKS.
CONTACT STATE, LOCAL AGENCY OR EPA (800-424-9346 OR 1-202-382-3000)
FOR FURTHER INFORMATION.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.